Basically, what is Rainwater harvesting?

Rainwater harvesting is the accumulating and storing of rainwater for reuse before it reaches the aquifer. It has been used to provide drinking water, water for livestock, water for irrigation, as well as other typical uses. Rainwater collected from the roofs of houses and local institutions can make an important contribution to the availability of drinking water. It can supplement the subsoil water level and increase urban greenery. Water collected from the ground, sometimes from areas that are especially prepared for this purpose, is called Stormwater harvesting. In some cases, rainwater may be the only available, or economical, water source. Rainwater harvesting systems can be simple to construct from inexpensive local materials, and are potentially successful in most habitable locations. Roof rainwater may not be potable and may require treatment before consumption. As rainwater rushes from your roof it may carry pollutants, such as mercury from coal burning buildings, or bird faeces. Although some rooftop materials may produce rainwater that would be harmful to human health as drinking water, it can be useful in flushing toilets, washing clothes, watering the garden, and washing cars; these uses alone halve the amount of water used by a typical home. Household rainfall catchment systems are appropriate in areas with an average rainfall greater than 200 mm (7.9 in) per year, and no other accessible water sources (Skinner and Cotton, 1992). Overflow from rainwater harvesting tank systems can be used to refill aquifers in a process called groundwater recharge; though this is a related process, it must not be confused with rainwater harvesting.

There are several types of systems to harvest rainwater, ranging from very simple home systems to complex industrial systems. The rate at which water can be collected from either system is dependent on the plan area of the system, its efficiency, and the intensity of rainfall (i.e., annual precipitation (mm per annum) x square meter of catchment area = litres per annum yield) … a 200 square meter roof catchment catching 1,000mm PA yields 200 kLPA.

Basic configuration

Rainwater harvesting systems channel rainwater from a roof into storage via an arrangement of gutters and pipes. The first flush of rainwater after a dry season should be allowed to run to waste, as it will be contaminated with dust, bird droppings etc. Roof gutters should be large enough to carry peak flows. Storage tanks should be covered to prevent mosquito breeding and to reduce evaporation losses, contamination and algal growth.

Quality

As rainwater may be contaminated due to pollutants like microscopic germs etc., it is often not considered suitable for drinking without treatment. However, there are many examples of rainwater being used for all purposes — including drinking — following suitable treatment.

Rainwater harvested from roofs can contain human, animal and bird faeces, mosses and lichens, windblown dust, particulates from urban pollution, pesticides, and inorganic ions from the sea (Ca, Mg, Na, K, Cl, SO4), and dissolved gases (CO2, NOx, SOx). High levels of pesticide have been found in rainwater in Europe with the highest concentrations occurring in the first rain immediately after a dry spell;[3] the concentration of these and other contaminants are reduced significantly by diverting the initial flow of water to waste as described above. The water may need to be analysed

System sizing

 

It is important that the system is sized to meet the water demand throughout the dry season. In general, the size of the storage tank should be big enough to meet the daily water requirement throughout the dry season. In addition, the size of the catchment area or roof should be large enough to fill the tank.

properly, and used in a way appropriate to its safety. In the Gansu province for example, harvested rainwater is boiled in parabolic solar cookers before being used for drinking.[4] In Brazil alum and chlorine is added to disinfect water before consumption.[citation needed] So-called “appropriate technology” methods, such as solar water disinfection, provide low-cost disinfection options for treatment of stored rainwater for drinking.

Ancient period

Rainwater harvesting has been used since biblical times. It was done in ancient Palestine, Greece and Rome. Around 3rd Century BC., farming communities in Baluchistan and Kutch used it for irrigation.[5]In Ancient Tamil Nadu, India, Rainwater harvesting were done by Chola kings.[6]Rainwater from Brihadeeswarar Temple was collected in Sivaganga tank.[7]In the Indus Valley Civilization, Elephanta Caves and Kanheri Caves in Mumbai rainwater harvesting alone has been used to supply in their water requirements.

Now

Currently in China and Brazil, rooftop rainwater harvesting is being practiced for providing drinking water, domestic water, water for livestock, water for small irrigation and a way to replenish ground water levels. Gansu province in China and semi-arid north east Brazil have the largest rooftop rainwater harvesting projects ongoing.

In Bermuda, the law requires all new construction to include rainwater harvesting adequate for the residents.

The U.S. Virgin Islands have a similar law.

In Senegal and Guinea-Bissau, the houses of the Diola-people are frequently equipped with homebrew rainwater harvesters made from local, organic materials.

In the United Kingdom water butts are often found in domestic gardens to collect rainwater, which is then used to water the garden. However, the British government’s Code For Sustainable Homes encourages fitting large underground tanks to new-build homes to collect rainwater for flushing toilets, washing clothes, watering the garden, and washing cars. This reduces by 50% the amount of mains water used by the home.

In the Irrawaddy Delta of Myanmar, the groundwater is saline and communities rely on mud-lined rainwater ponds to meet their drinking water needs throughout the dry season. Some of these ponds are centuries old and are treated with great reverence and respect.

Until 2009 in Colorado, water rights laws almost completely restricted rainwater harvesting; a property owner who captured rainwater was deemed to be stealing it from those who have rights to take water from the watershed. Now, residential well owners that meet certain criteria may obtain a permit to install a rooftop precipitation collection system (SB 09-080).[8] Up to 10 large scale pilot studies may also be permitted (HB 09-1129).[9] The main factor in persuading the Colorado Legislature to change the law was a 2007 study that found that in an average year, 97% of the precipitation that fell in Douglas County, in the southern suburbs of Denver, never reached a stream—it was used by plants or evaporated on the ground. In colorado you cannot even drill a water well unless you have at least 35 acres. In New Mexico, rainwater catchment is mandatory for new dwellings in Santa Fe.[10]

In Beijing, some housing societies are now adding rain water in their main water sources after proper treatment.

Professor Micheal McGinley established a project to design a rain water harvesting prototype in the Biosystems design Challenge Module in University College Dublin.

In Australia rainwater harvesting is typically used to supplement the reticulated mains supply. In south east Queensland, households that harvested rainwater doubled each year from 2005 to 2008, reaching 40% penetration at that time (White, 2009 (PhD)).

In IndiaIn Tamil Nadu, India rainwater harvesting was made compulsory for every building to avoid ground water depletion. It proved excellent results within five years and every other state took it as role model. Since the implementation, Chennai saw 50 per cent rise in water level in five years and the water quality significantly improved.[11] [12]

In Rajasthan, India rainwater harvesting has traditionally been practiced by the people of the Thar Desert. There are many ancient water harvesting systems in Rajasthan, which have now been revived [13]